Installing a Brick Paver Walkway or Loose Bricks

Making use of Installing a Brick Paver Walkway or Used Brick or Pavers to create a pathway or patio area matches a home in a way that is unrivaled. It adds a level of quality and sophistication to a home entryway that can not be achieved with either concrete or asphalt. Brick and Pavers likewise come in various colors and shapes enabling distinct color design and patterns to be attained. In addition, setting up a Brick or Paver sidewalk does not always need a pro. With some fundamental understanding and a fairly simple sidewalk plan, a homeowner can carrying out such a job.

The secret to setting up a Brick or Paver Walkway is to first properly prepare the location where the bricks/pavers are to be installed. In addition, string lines should be strung on each side of the sidewalk.
When the area has actually been dug down, 3/4" gravel stone need to be laid in and tamped down firmly. Then 2" of sand, or stone dust must be topped the gravel. Once again the sand/stone dust must be tamped down. Stone dust is preferred. The height in between the tamped down sand and the stringline should equate to the thickness of the brick or paver.

Now that you have a steady base, place a 1" pipeline or journal board the length of the pathway on either side of the sidewalk. Using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will create a level area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Set up an operate on both sides of the ready location. These strips will serve as your walkway border and aid to preserve the integrity and shape of the walkway. You can get these plastic strip borders at most house enhancement stores. The strips need to be anchored down with 12" galvinized nails. You ought to sink these nails into the ground and through the strips every foot.

You can then begin to lay the bricks/pavers once this is done. There are lots of patterns you can lay. I especially like the Herring Bone pattern. The key to laying the bricks/pavers is to ensure that they interlock with each other. Always stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will once again assist keep the integrity of the sidewalk.

Undoubtedly bricks/pavers will need to be cut or split when building the sidewalk. Unless you wish to buy or rent a pricey wetsaw, I would recommend buying a basic brick/paver splitter. It is generally a chisel with a large end that is the width of the bricks/pavers. To really cut/split the brick/paver, lay it in a bed of sand and location the sculpt at a 75 degree angle over the spot where you wish to break the brick. Utilizing a hammer strike the butt end of the chisel firmly. You might need to do this a number of times. You might also want to flip the brick/paver over and strike the other side of the brick utilizing the hammer and chisle. Within a couple of strikes the brick/paver should break cleanly. If your pathway has curves you will require to buy/rent a wetsaw.

After setting up the bricks, develop the outside edges with additional sand, and then shovel in the topsoil and pack down firmly.
Spread stone dust over the brand-new pathway and sweep into the fractures. This will complete the interlocking of the bricks and assist to eliminate any weed development.


In addition, installing a Brick or Paver sidewalk does not necessarily need a pro. The key to setting up a Brick or Paver Walkway is to first effectively prepare the location where the bricks/pavers are to be installed. Now that you have a steady base, place a 1" pipe or journal board the length brick crusher of the pathway on either side of the sidewalk. These strips will act as your sidewalk border and assistance to maintain the stability and shape of the walkway. Inevitably bricks/pavers will require to be cut or divided when building the pathway.

Leave a Reply

Your email address will not be published. Required fields are marked *